Thermaltake Pacific CLM480 Radiator Copper

In Stock

Rp1.950.000

Qty
  • Spesifikasi, stock dan harga dapat berubah sewaktu-waktu tanpa pemberitahuan terlebih dahulu.
  • Spesifikasi dan fitur dapat berubah sewaktu-waktu tanpa pemberitahuan terlebih dahulu.
  • Gambar adalah ilustrasi dan dapat berubah sewaktu-waktu tanpa pemberitahuan terlebih dahulu.
  • Harap lakukan konfirmasi terlebih dahulu sebelum membeli.
More Information
P/N CL-W238-CU00BL-A
DIMENSIONS 526.6(L) x 119 (W) x 40(H)
WEIGHT 1269 g
MATERIAL Copper
FPI (FIN PER INCH) 14
FLAT TUBE 12 set
THICKNESS 40 mm
PARTS Stopper *3 (G 1/4 )
SCREW THREAD G¼” * 5

 

High-Quality Copper Radiator Design

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

  • To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
  • Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
  • Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
  • Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
  • DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
  • Fill the reservoir to the top as it will prevent air from going into the pump
  • If necessary tilt the system slightly from side to side to bleed the air out of the loop.
  • Place some paper towels under fittings and joining points to test for leaks.
  • Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
  • Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
  • Coolant might fade over time.
Weight 6 kg

Reviews

There are no reviews yet.

Be the first to review “Thermaltake Pacific CLM480 Radiator Copper”

Your email address will not be published. Required fields are marked *

Tujuan Pengiriman

Top