Thermaltake Pacific RGB Plus TT Premium Edition G1/4 PETG Tube 16mm OD 12mm ID Fitting (6-Pack Fittings)

In Stock

Rp1.650.000

Qty
  • Spesifikasi, stock dan harga dapat berubah sewaktu-waktu tanpa pemberitahuan terlebih dahulu.
  • Spesifikasi dan fitur dapat berubah sewaktu-waktu tanpa pemberitahuan terlebih dahulu.
  • Gambar adalah ilustrasi dan dapat berubah sewaktu-waktu tanpa pemberitahuan terlebih dahulu.
  • Harap lakukan konfirmasi terlebih dahulu sebelum membeli.
More Information
P/N CL-W185-CU00BL-A
DIMENSIONS Ø25 x 31.4 H mm
WEIGHT 720g
INTERFACE USB 2.0 connectors (9 Pin)
SYSTEM COMPATIBILITY Windows 7 / 8 / 8.1 / 10
POWER INPUT 0.5 W (one fitting)
COMPATIBILITY 16mm OD /12mm ID hard tube
MATERIAL Copper
RATED VOLTAGE 5V
THREADS G ¼”
NOTE 6 Pack

 

*The image is for reference only.

 

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks

  • To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
  • Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
  • Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup

  • It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
  • Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
  • DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
  • Fill the reservoir to the top as it will prevent air from going into the pump
  • If necessary tilt the system slightly from side to side to bleed the air out of the loop.
  • Place some paper towels under fittings and joining points to test for leaks.
  • Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
  • Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
  • Coolant might fade over time.
Weight 2 kg

Reviews

There are no reviews yet.

Be the first to review “Thermaltake Pacific RGB Plus TT Premium Edition G1/4 PETG Tube 16mm OD 12mm ID Fitting (6-Pack Fittings)”

Your email address will not be published. Required fields are marked *

Tujuan Pengiriman

Top